Evidence of reverse and intermediate size segregation in dry granular flows down a rough incline

Nathalie Thomas and Umberto D'Ortona
Phys. Rev. E 97, 022903 – Published 9 February 2018

Abstract

In a dry granular flow, size segregation had been shown to behave differently for a mixture containing a few large particles with a size ratio above 5 [N. Thomas, Phys. Rev. E 62, 961 (2000)]. For moderately large size ratios, large particles migrate to an intermediate depth in the bed: this is called “intermediate segregation.” For the largest size ratios, large particles migrate down to the bottom of the flow: this is called “reverse segregation,” in contrast with surface segregation. As the reversal and intermediate depth values depend on the fraction of particles, this numerical study mainly uses one single large tracer. Small fractions of large beads are also computed showing the link between single tracer behavior and collective segregation process. For each device (half-filled rotating tumbler and rough plane), two (2D) and three (3D) dimensional cases are distinguished. In the tumbler, the trajectories of a large tracer show that it reaches a constant depth during the flowing phase. For large size ratios, this depth is intermediate. A progressive sinking of the depth is obtained when the size ratio is increased. The largest size ratios correspond to tracers being at the bottom of the flowing layer. All 3D simulation results are in quantitative agreement with the experimental surface, intermediate, and reverse-segregation results. In the flow down a rough incline, a large tracer reaches an equilibrium depth during flow. For large size ratios, the depth is inside the bed, at an intermediate position, and for the largest size ratios, this depth is reverse, located near the bottom. Results are slightly different for a thin or a thick flow. For 3D thick flows, the reversal between surface and bottom positions occurs within a short range of size ratios: no tracer stabilizes near half-height and two reachable intermediate depth layers exist, below the surface and above the bottom reverse layer. For 3D thin flows, all intermediate depths are reachable by a tracer, depending on the size ratio. The numerical study of larger fractions of tracers (5% or 10%) shows the three segregation patterns (surface, intermediate, reverse) corresponding to the three types of equilibrium depth. The reversal is smoother than for a single tracer, and happens around the size ratio 4.5, in good agreement with experiments.

  • Figure
  • Figure
  • Figure
  • Figure
  • Figure
  • Figure
  • Figure
20 More
  • Received 13 December 2016
  • Revised 23 November 2017

DOI:https://doi.org/10.1103/PhysRevE.97.022903

©2018 American Physical Society

Physics Subject Headings (PhySH)

Fluid DynamicsCondensed Matter, Materials & Applied Physics

Authors & Affiliations

Nathalie Thomas*

  • CNRS, Aix-Marseille Univ., IUSTI UMR 7343, 13453, Marseille, France

Umberto D'Ortona

  • CNRS, Aix-Marseille Univ., Centrale Marseille, M2P2 UMR 7340, 13451, Marseille, France

  • *nathalie.thomas@univ-amu.fr

Article Text (Subscription Required)

Click to Expand

References (Subscription Required)

Click to Expand
Issue

Vol. 97, Iss. 2 — February 2018

Reuse & Permissions
Access Options
Author publication services for translation and copyediting assistance advertisement

Authorization Required


×
×

Images

×

Sign up to receive regular email alerts from Physical Review E

Log In

Cancel
×

Search


Article Lookup

Paste a citation or DOI

Enter a citation
×